ATTENTION!!!
Out of production product. CBE Official Repair Service available.
The A910/6 charger is designed to recharge lead-acid starter or stationary (gel) batteries, for use
continuous and connected in a buffer system:
- It can remain connected to the 230V network continuously, as the system automatically selects the charge in relation to the battery status.
- If the battery with at least 3V is not connected, the system will not function.
- The charging system takes place in three cycles:
1. charge the battery at maximum current until the end of charge of 14.5V is reached (red LED).
NB. The end of the charge is reached only if the battery is efficient.
2. Timed completion charge at a constant 14.5V for a time of: 20 min. (PB batt.), 6 hours and 20 min. (gel batt.).
3. Maintenance 13.8V constant (green LED) This ensures the maintenance current for a full charge.
In this phase the system partially powers the thyristors so as to reduce the voltage peak to almost zero.
When the battery drops below a value of approximately 13.6V, also due to the insertion of a load (users), the system restarts from phase 2.
An electronic device disconnects all 12V utilities when the service battery reaches the minimum voltage level of 10V. It is possible to restore them for about a minute by turning the main switch on the control panel off and on again.
The trivalent refrigerator, electric step, heating / boiler are excluded from this device.
NB: Product not compatible with A910-6AF
We can send the A910-6AF model to CBE for repair
TECHNICAL INFORMATION
- Model CBE A910/6
- Rated Voltage: 230Vac / 50Hz
- Rated power: 150VA
- Protection fuse: 2A (5x20 glass)
- Maximum current: 10A
- Load line: IWUoU
- Battery type selector: Pb-Acid / Pb-Gel
- Short circuit protection and reverse polarity protection
- Connections: cable L= 1m with Schuko plug
- Consumption without mains: 12V 0.3 mA
- Container material: Painted aluminum
- Dimensions: 270x 170 h100 mm
- Weight: 4 Kg
Specific References
- EAN13
- 8033087738445
- MPN
- A910-6
16 other products in the same category:
The
Power Bank Start-E 18000 by EZA is the compact but powerful solution for
those who travel, work on the move or love adventure. With a current of
900A peak and starting capacity up to 6 liter petrol engines and
4.5 liter diesel, it is...
New!!! The BC122 switching is a high efficiency battery charger (without cooling fan) for lead, gel, lithium and AGM batteries. Batteries must have a nominal voltage of 12V and a capacity adequate for the battery charger current (check the...
The AC/DC charger recharges the auxiliary battery of your recreational vehicle. It converts alternating current (from a 230V P17 socket) into direct current (12V). With this portable charger, to always carry with you, you can recharge your battery...
NE287 CHARGER ADAPTER CABLE This cable is required for installing the NE287 charger as a replacement for the older NE 146 and NE186 models. TECHNICAL DATA: Brand: NordElettronica Model: 000.402.92
The CBE CB516-24 switching battery charger ?CB500? series 24V is able to charge lead batteries ( lead-acid and lead-gel ) automatically. The battery charger is protected against overtemperature and the 24V outputs are protected against short...
NORDELETTRONICA BATTERY CHARGER MODEL NE 287 21 A Standard battery chargers compatible with all types of gel, AGM, lead and LiFePO4 batteries. Charging is performed by maintaining constant current and voltage. This implies a reduced charging time...
NORDELETTRONICA BATTERY CHARGER MODEL NE 287 17A Standard battery chargers compatible with all types of gel, AGM, lead and LiFePO4 batteries. Charging is performed by maintaining constant current and voltage. This implies a reduced charging time...
AC/DC CHARGER 20A EZA POWER EZA POWER chargers have a complete range of 4-70 Amps that allow efficient charging of the auxiliary battery via the 230V electrical network. From the 10A model onwards, they integrate multiple parameterization of the...
NEW MODEL BATTERY CHARGER CBE CB522-3 FOR CAMPERS AND BOATING The CBE CB522-3 switching battery charger ?CB500-3? series is able to charge lead batteries (lead-acid, lead-gel, AGM) on board the camper automatically and with innovative charging...
EZA POWER 20A AC/DC BATTERY CHARGER EZA POWER chargers have a full range of 4-70 Amps which allow efficient charging of the auxiliary battery via the 230V mains. Starting from the 10A model, they integrate multiple parameterization of the...
EZA POWER 40A AC/DC BATTERY CHARGER for Lithium Batteries EZA POWER chargers have a full range of 4-70 Amps which allow efficient charging of the auxiliary battery via the 230V mains. Starting from the 10A model, they integrate multiple...
NE143 to NE287 CHARGER ADAPTER CABLE This cable is required for installing the NE287 charger to replace the old NE143 model TECHNICAL DATA: Brand: NordElettronica Model: 000.402.94
EZA POWER 30A AC/DC BATTERY CHARGER EZA POWER chargers have a full range of 4-70 Amps which allow efficient charging of the auxiliary battery via the 230V mains. Starting from the 10A model, they integrate the multiple parameterization of the...
NEW MODEL BATTERY CHARGER CBE CB516-3 FOR CAMPERS AND BOATING The CBE CB516-3 switching battery charger ?CB500-3? series is able to charge lead batteries (lead-acid, lead-gel, AGM) on board the camper automatically and with innovative charging...
EZA POWER 70A AC/DC LITHIUM CHARGER Eza has a complete range of AC/DC chargers. From 4 to 70 amps, they provide high performance charging of your leisure vehicle's auxiliary battery via the 230V mains supply. Starting from the 10A model, these...
The CBE CB510-3 ?CB500? series switching battery charger is able to charge lead batteries (lead-acid and lead-gel) automatically. The battery charger is protected against overtemperature and the 12V outputs are protected against short circuit and...
