The CBE BMTG is the new sensor for LPG and soporific gas for campers and boats and replaces the CBE MTG.
The CBE BMTG detector is able to detect the presence of LPG (liquefied petroleum gas) and ether gas (narcotic effect) in the air; an acoustic signal warns of the presence of gas in the air before it has an effect on people inside the passenger compartment and before its concentration reaches a tenth of the minimum value necessary to trigger a possible explosion.
The two calibration levels present on the circuit allow you to adjust the sensitivity of the sensor based on the use and the chosen installation position.
Each detector is tested and calibrated with reference gas; the sensor life is approximately 10 years.
Built-in version; complete with ?BMAC2? frame. The detector can be combined with the ?MODULAR PLATES BERKER? series.
TECHNICAL INFORMATION
- Model: CBE BMTG
- Color: Anthracite Grey RAL7021
- Power supply: 12V
- Dimensions: 119 x 60 mm
- Sensor consumption: 75mA
- Acoustic power ( buzzer ): 85 dB at 1 meter
16 other products in the same category:
Kit consisting of a 1kg 29 mbar low pressure LPG regulator, GS 25 H13 hexagonal swivel ( Italy ), Ø10 UNI fixed calibration hose holder, cylinder key, two hose clamps and 1.5m of rubber hose. Attention: This kit is not suitable for campers, it is...
750mm gas hose for gas systems on campers, caravans, caravans and foodtracks. Equipped with steel fittings. TECHNICAL INFORMATION Length: 750 mm Attack A: Italian Cylinder Attack B: Pressure regulator attack Italy
Truma Corner Fitting for Combi Stove with John Guest 10 Connection and 10 mm Pipe Camper For truma models 34020-63900
The AKV-8 GAS valve is equipped with a quick-release coupling on one side, the fittings have the classic 8 mm ogive connection TECHNICAL INFORMATION Brand: Truma Attack 1: Gas quick coupler A ttachment 2: ø 8 mm Connection 3: ø 8 mm
The Cavagna Group gas pressure regulator meets all European requirements for the use of the gas system while driving. Use only a high-pressure hose to connect to the gas cylinder. The gas cylinder must always be kept in a vertical position. When...
FEMALE BRASS CONNECTOR ITALIAN CYLINDER Adapter for German regulator to Italian cylinder German male-Italian female connection Material: Brass Article: 46083 Internal diameter Female (Italian): 21.6mm Male diameter (German) DIN477: 19.7mm
GAS LEAK DETECTOR MCR TRIO-GAS Trivalent gas leak detector, device suitable for detecting the presence of LPG / CARBON MONOXIDE / SOPORIFYING GASES (ether and derivatives). It has 3 LEDs, a test button and provides an acoustic signal during its...
GAS T-fitting in steel diameter 8mm Camper Caravan
TRUMA ABO TB KIT REPLACEMENT WATER CONNECTOR BOILER TECHNICAL INFORMATION Brand: Truma Manufacturer code: 70400-01
TRUMA DUOCONTROL CS VERTIKAL In the camper or caravan, two gas cylinders can be connected to the new generation Truma DuoControl CS gas pressure regulator. When the operating cylinder is empty, the system automatically switches to the reserve...
Biconical fitting with hose clamp for gas pipes diameter 8 mm TECHNICAL INFORMATION Connection diameter: 8 mm
8mm pipe fitting and 10mm pipe clamp
The MonoControl CS gas pressure regulator meets all European requirements for the use of the gas system while driving. Use only a high-pressure hose with rupture protection to connect to the gas cylinder ( not included in the package ). The gas...
M20 water angle connection for Truma boiler with John Guest connection TECHNICAL INFORMATION Brand: Truma Manufacturer code: 34151-03 Connection diameter: M20 / John Guest 12
The Cavagna Group gas pressure regulator meets all European requirements for the use of the gas system while driving. Use only a high-pressure hose to connect to the gas cylinder. The gas cylinder must always be kept in a vertical position. When...
Customers who bought this product also bought:
12V DISTRIBUTION PANEL FOR PC-100 / 200 CBE DS300 distribution board, 12V power supply, with 3, 5, 10, 20, 25 and 30 A fuses. It comes complete with the fuses, connections and pins needed for use in your caravan, motorhome or boat. TECHNICAL...
NEW MODEL BATTERY CHARGER CBE CB516-3 FOR CAMPERS AND BOATING The CBE CB516-3 switching battery charger ?CB500-3? series is able to charge lead batteries (lead-acid, lead-gel, AGM) on board the camper automatically and with innovative charging...
The CBE BMTCO is the new carbon monoxide sensor for campers and boats. The BMTCO detector is able to detect the presence of carbon monoxide (CO) in the air; an acoustic signal warns of the presence of gas in the air before it affects people inside...
Replacement cover for CBE R431 built-in 230V CEE male plug. TECHNICAL INFORMATION Size: 100 x 160 mm Color: white Model: CBE R431-C
